Deslauriers Impalement Safety Covers

• Fits rebar #3-8, 3/8" to 7/8" diameter

• Lightweight and chemical resistant

• Stands up to weather and temperature conditions

• Safety orange color provides visibility

• Dimension: 3.5" W x 3.5" H

Approved by California OSHA #C1718AG and OSHA 1723AG

Deslauriers' Caps are steel reinforced and conform to State and Federal safety regulations.

• Complies with Federal OSHA 701 (b).
• Federal OSHA has ruled that if cover is in compliance with Cal OSHA, then it conforms to Fed. 701 (b).

BARGARD® caps are not designed or intended to provide impact or impalement protection. They are not a substitute for covering vertical reinforcing steel with timber, as recommended by OSHA, and are not recommended for use when protection from falls is required. For additional information on acceptable methods of guarding against impact or impalement, consult OSHA CFR TITLE 29, PART 19120, ANSI A10.9-1983, and your state regulations for specific requirements.

Sold by the each

cal_osha_approval.pdf

• Economical
• When force is applied to the Carnie Cap system, the impact is distributed evenly over the entire length of the lumber.
• Meets OSHA standards for withstanding a 250 pound weight dropped from 7’6" without the rebar breaking through
• Meets CAL-OSHA Construction Safety Orders Section #1712 on impalement protection from concrete reinforcing bars.
• Made of rugged, sturdy and reusable plastic.
• Quick and easy to install.
• Eliminates costs associated with injuries and downtime from rebar impalement.
• Available for use on 2" x 4"
• Fits rebar sizes #3-#9 and #5-#18.
• Works in vertical, incline and horizontal applications.
• Uses only 2 caps per each 8 foot span. (in California, double the thickness of the lumber and space no greater than 4 feet apart.)
• Enables contractors to more efficiently use concrete blankets by utilizing the lumber as protective support so blankets don’t become torn.